bin file, secondary(USB) boot-loader needs to be flashed to the controller. Now the controller should run your application code.Ĭheck this tutoial LPC1768 Keil Setup for generating the. Once the hex file is flashed, Reset the board.Hit the Start Button to flash the hex file.If DTR and RTS are used then go to Options->Advanced Options-> Hardware Config and select the Use DTR and RTS Option.Check the Verify After Programming Option.Check the Erase blocks used by Hex file option.Check the device manger for detected Com port. Now open the flash magic software and follow the below steps. Now the Boot Contoller will be in ISP/PRI_BLD mode and you can flash the hex file using flash magic. Note: If your converter does not have DTR and RTS lines, "hold down the ISP/PRI_BLD switch, RESET the board(press and release reset switch) and then release the ISP switch ". The neat thing about the NXP controllers is, they come with a UART boot-loader from the factory. You need a USB to Serial(UART) convertor in order to get this working. The board is shipped with USB bootloader, if you want to use it directly follow the steps on how to flash the bin file.Ĭheck the tutoial LPC1768 Keil Setup for generating the. bin, no external hardware is required but board should have the secondary boot loader. bin files to Lpc1768 board.įor flashing the hex files, we will be using the flash magic software along with a Usb to Serial converter. In this tutorial we will be discussing how to upload the.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |